- Navigate to ‘Control Lights from AV Keypad’ and uncheck the "Include <CR>" checkbox below the command header
- Enter these 3 ADR Commands and configure corresponding light actions (scenes)
For information on creating and configuring Scenes, click here
ADR Commands | Suggested Lighting levels for Scene | For devices having only ON/OFF controls |
DR_UARTCODE_LEVEL_HIGH (peak demand) | OFF or low brightness Scene | OFF Scene |
DR_UARTCODE_LEVEL_MEDIUM (medium demand) | ON Scene with medium brightness | ON/OFF scene based on need |
DR_UARTCODE_LEVEL_NORMAL (low or normal demand) | ON scene with required max brightness | ON Scene |
- To setup the light Action for each command
- Tap the Settings button in the light action box.
- Select the required Scene from the dropdown list and tap OK.
Note – for any controllers that requires only relay ON/OFF functions (eg: Plug loads), configure 2 scenes with ON and OFF actions. Configure the medium level command and scene based on personal preference.
After all these configurations, when an OpenADR command is received by the Enor EU gateway, the Green LED on Enor EU will blink rapidly, and the light devices will go to the configured scene based on the commands.
Refer the spec sheet for wiring and Hardware specification details
2. Enor EU
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article