Control AV system from Lighting Keypad

Modified on Tue, 6 May at 4:25 AM

The Lumos lighting keypad can be used to control both lighting and AV equipment. Follow the steps below to set this up:

Pair the Lumos switch (lighting keypad) with your lighting system.

For information on how to commission and configure the switches, click here

2. Go to:

Device Settings → AV Integration Settings → Control AV from Lighting Keypad

3. Select the Lumos switch that will control the AV system.

Note:

User has the option to add the required switch
Up to 5 light switches can be added to configure AV control using 1 Enor EU gateway

For adding lighting keypad, select the corresponding ‘+’ sign

Eg: if user is selecting 8 button AC switch, then show 8 buttons to setup the AV command.

4. Configure each button on the switch with the desired Lighting Actions
(e.g., “Button 1: set lights to 3000K and 50% brightness”).

Default names shall be Button-1, Button-2 etc

Select the button name to open a text box
Add the desired name and press ‘OK’ button.

Note: The character limit can be 20 including spaces and it should not be blank

5. Enter the AV command that should be sent to the AV system when a specific button is pressed

(e.g., PRESENT_ON).

Note the following:

The command shall be of 32 characters maximum
Commands can end with <CR> if needed. A checkbox (checked by default) lets users include it, and the input box shows <CR> when selected.

When the AV command input box is selected, a pop-up text box appears

Add the required command, press the ‘OK’ button.

6. Set lighting action: An option to view the lighting action configured for each button of the selected Lumos switch (via switch configuration page of switch)

This is required to setup the AV commands for a button by identifying the related lighting action configured

Select the ‘Save’ button to save the configurations
Selecting the ‘Delete’ button will delete the switch "Switch name" from the AV integration settings and clear all the AV commands configured on its buttons.

Note: This shall not clear any lighting action configured on the buttons. Only delete the AV commands configured and remove the switch and the loaded data from the UI.