Customize the light level to be maintained by a device when powered

1. Go to the 'Devices' tab
2. Click on the icon of the light device (for DALI, click on the icon corresponding to the parent device)
   
3. Select 'Light Configuration Settings'
   
4. Go to 'When powered, turn On with'
   1. Previous state: Select this if the light should adopt the previously lit state
   2. Scene: Select this if the light should adopt settings from a preconfigured scene (Only available for Radiar ARD4 and ARD32)
   3. Custom: Select this if the light should turn ON with a custom intensity level (Only available for Radiar AR10, AF10, D10, AFD1 and Ldrive 32W, 42W, 36W, 60W)

You can also visit the following sections for more information:
To understand how to configure Turn On delay (Radiar AF10), click here

To understand how to configure 'Device Power Settings', click here
To understand how to configure 'Device Configuration Settings', click here
To understand how to configure 'Input Sensor Settings' of Radiar AR10/AF10, click here
To know how to commission Sensor, click here
To commission Catron IV, click here
To commission Gateway in Wi-Fi mode, click here
To commission Repeaters, click here