Configure 'Device Configuration Settings' prior to device commissioning

1. Choose the zone from the top right corner of the app 
2. Go to the 'Devices' tab in the app
3. Click on the '+' button and choose the option 'Add Device'
   
4. Click on the option 'Commissioning Settings' and choose 'Device Configuration Settings'
   

Report Light Status

• Upon change: If enabled, light status will be sent to the server only when it changes (default: disabled)
• Periodically: If enabled, the current light status will be sent to the server at the specified interval (default: enabled)
  • Set time interval in minutes: You can configure the interval at which the current light status must be sent to the server
    • The default value of this interval is 5 min and can be configured between 0.5-127 min

Participate in retransmission: If enabled, the devices will retransmit all the data packets received (default: enabled) 

Connectable mode: If enabled, the device will establish a connection for reliable communication (default: disabled)

Traffic monitoring: If enabled, the network traffic will be optimized (default: enabled)

Non flooded mode: If enabled, the mesh performs a leader node election to reduce flooding of data packets in the mesh (default: disabled)

Listener mode: If enabled, the device will act as Listeners (default: disabled)

Feedback: If enabled, the devices will send feedback (default: enabled)  

• 
  
  • If Feedback is enabled, configure the interval at which the devices should send feedback
  • This value can be configured between 85-200 milliseconds

You can also visit the following sections for more information:
To configure 'Device Power Settings' prior to device commissioning, click here
To know how to commission Controllers, Ldrives, and Dimmers, click here
To know how to commission Sensor, click here
To commission Catron IV, click here
To commission Gateway in Wi-Fi mode, click here
To commission Repeaters, click here