Configure 'Output Channel Settings' for Controller prior to device commissioning

1. Choose the zone from the top right corner of the app 
   
2. Go to the 'Devices' tab in the app
3. Click on the '+' button and choose the option 'Add Device'
   
4. Click on the option 'Commissioning Settings' and choose 'Output Channel Settings'
   
5. Click on the tab 'Controller' to configure the output channel settings for controllers and go to the option 'Choose channel mode'
   

   1. Single Channel + Relay

      1. Choose this as the output channel mode, if only one channel of the controller is connected

      2. The second channel will act as an external relay input

      3. This mode will support On/Off and intensity control of the device

   2. Controller-Based Color Tuning

      1. Choose this as the output channel mode, if both channels of the controller are connected and when the connected driver does not have the capability to perform color tuning

      2. In this mode, the controller will perform color tuning

      3. This mode will support On/Off, intensity, and CCT control

   3.  Driver-Based Color Tuning

      1. Choose this as the output channel mode, if both channels of the controller are connected and when the connected driver has the capability to perform color tuning

      2. This mode will  support On/Off, intensity, and CCT control

   4. 2 Single Channels

      1. Choose this as output channel mode, if both channels of the controller are connected and when the requirement is to independently control the intensity of both the channels

      2. This mode will support On/Off and intensity control for each of the channels

   5. Relay

      1. Choose this mode as the output channel mode if the controller is being set up for plug load control

      2. In this case, the second channel will perform On/Off operations

6. Go to the option 'Choose Device Mode"
   1. From this option, you can choose if the devices like Radiar ARD4, Radiar ARD32, and Radiar AFD1 should be commissioned as DALI controllers or 0-10V controllers
   2. On choosing 'DALI', these devices will be commissioned as DALI controllers and on choosing '0-10V', these devices will be commissioned as 0-10V controllers
   3. For choosing a different device mode for a commissioned device, it needs to be deleted and commissioned again

You can also visit the following sections for more information:
To configure 'Output Channel Settings' for Ldrive prior to device commissioning, click here
To know how to commission Controllers, Ldrives, and Dimmers, click here
To know how to commission Sensor, click here
To commission Catron IV, click here
To commission Gateway in Wi-Fi mode, click here
To commission Repeaters, click here