Data displayed in the Energy Consumption - Analytics report

Energy consumption data may be represented in kWh or cost (Euro or dollars). The cost shall be calculated based on the rate per kWh and currency configured in Report settings. By default, data shall be represented in kWh and the floor-based and time-based graph of the building shall be displayed. Filters are available to see data at a Zone, Group, or Device Level.

The expected energy consumption for a building can be configured in Report settings for a day and the savings for the day/week/month shall be computed by taking the difference between the actual energy consumption for the day/week/month and this configured value. If the user has not configured this value, savings shall be computed by taking the difference between the actual energy consumption for the day/week/month and the maximum energy consumed so far for a day/week/month (depending on the duration chosen-day/week/month in the reports page).

The information about the building's total energy consumption, most energy-consuming floor(s) and its consumption, least energy-consuming floor(s) and its consumption, Savings (if any) shall be displayed by default if no filter has been applied. If a floor is selected from the filter, data about the floor's total energy consumption, most energy-consuming zone(s)of that floor and its consumption, least energy-consuming zone(s), and its consumption shall be displayed. If a zone is selected from the filter and

• the groups tab is chosen, data about the zone's total energy consumption, most energy-consuming group(s) of that zone and its consumption, least energy-consuming group(s), and consumption shall be displayed
• the devices tab is chosen, data about the zone's total energy consumption, most energy-consuming device(s) of that zone, and its consumption, least energy-consuming device(s), and its consumption shall be displayed

If a group is selected from the filter, data about the group's total energy consumption, most energy-consuming device(s)of that group and its consumption, least energy-consuming device(s) and its consumption shall be displayed. If a device is selected from the filter, only its time-based analysis graph will be shown.

You can also visit the following sections for more information:
To know on how values are calculated for the Energy Consumption reports, click here
To know about the Devices needed to perform smart Emergency testing using the Lumos Controls system, click here
To know how does the Lumos Controls BMS integration work, click here