Configure 'Device Configuration Settings'

Device configuration settings define the relevant settings to be configured for a device while operating as a mesh device.

1. Go to the 'Devices' tab
2. Click on the  icon of the device
3. Select the 'Additional Settings' option and choose 'Device Configuration Settings'
   

Report Light Status

• Upon change: If enabled, the light status will be sent to the server only when it changes (default: disabled)
• Periodically: If enabled, the current light status will be sent to the server at the specified interval (default: enabled)
  • Set time interval in minutes: You can configure the interval at which the current light status must be sent to the server
    • The default value of this interval is 5 min and can be configured between 0.5-127 min

Participate in retransmission: If enabled, the devices will retransmit all the data packets received (default: enabled) 

Connectable mode: If enabled, the device will establish a connection for reliable communication (default: disabled)

Traffic monitoring: If enabled, network traffic will be optimized (default: enabled)

Non-flooded mode: If enabled, the mesh performs a leader node election to reduce flooding of data packets in the mesh (default: disabled)

Listener mode: If enabled, the device will act as Listeners (default: disabled)

Feedback: If enabled, the devices will send feedback (default: enabled)  

• If Feedback is enabled, configure the interval at which the device should send feedback
• This value can be configured between 85-200 milliseconds

You can also visit the following sections for more information:

To understand how to configure 'Input Sensor Settings' of Radiar AR10/AF10, click here
To know how to commission Sensor, click here
To commission Catron IV, click here
To commission Gateway in Wi-Fi mode, click here
To commission Repeaters, click here