Configure Emergency Test Settings

1. Click on Emergency Settings from Emergency Lighting dashboard
     
   
2. Select the device whose settings are to be changed and click on the 'Edit' button
   
   
3.  The Test execution timeout time and the emergency duration time to be extended can be set. 
   
   

   Test execution Timeout: It is the time allowed for the test to be completed. If the test runs after this specified time, the test will be executed and will be considered as failed.

   Extend Emergency Duration by: This option can be used to extend the duration for which you want the lights to be in emergency lighting mode even after the power is restored. 
   
   Once the settings have been changed, the status will show ‘Pending’ or ‘Retry’. The status will change to ‘Success’ indicating that the set values have been communicated to the device. In case of any failures, the status will change to ‘Retry’. The ‘Retry’ option on the bottom right can be used to retry and make sure that the values are sent to the devices again.

You can also visit the following sections for more information:
To know how to view Emergency Test Reports, click here
To know how does the Lumos Controls BMS integration work, click here